Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Before
After
Before
After
Before
AfterChimney Cleaning in Des Moines, WA
Chimney cap and crown work in Des Moines runs $350-$1,800 depending on whether we’re fitting a new cap or rebuilding a spalled crown. Most Des Moines calls start with the same complaint: water staining on the ceiling near the fireplace, or pieces of mortar washing out onto the roof after a wet winter. We’re Level Two Chimney Co., and we handle that with a camera-scan inspection, a written price before any work starts, and a documented photo record under Haven Standard Clause 4. Call (425) 642-3485 for a free estimate.
Why Des Moines Homes Are Different
Des Moines sits directly on Puget Sound’s eastern shore, and that salt-laden marine air eats mortar joints faster than anything you’ll see inland. The 1950s-1970s ranch homes and split-levels that dominate the city carry original masonry chimneys now 50-60 years into chronic moisture exposure. Clay tile liners in these systems crack and spall predictably.
The marine climate keeps everything damp, so moss and lichen colonize crowns and caps within a season or two. And because winters stay mild and overcast, residents burn low-temperature smoldering fires - the exact condition that builds glazed creosote. Homes on the bluff above Des Moines Marina catch unobstructed southwest wind off the water; we’ve found that smoke-backdraft complaints there are usually wind-induced downdraft, not blockage, and need a wind-directional cap rather than a sweep.
Our Main Des Moines Services
Des Moines homeowners call us most often for these three services:
Chimney Cleaning & Sweep in Des Moines
We clean and inspect masonry and factory-built systems throughout Des Moines, from the waterfront cottages to the mid-century ranches inland. Every sweep includes an NFPA 211 Level 2 camera inspection and a documented photo record. Chimney Cleaning & Sweep in Des Moines covers creosote removal, obstruction clearing, and condition reporting with a written price before we start.
Chimney Repair in Des Moines
Moisture damage shows up here as spalling brick, deteriorated mortar joints, and cracked crowns. We repair with materials matched to Puget Sound’s wet climate, and every job gets a written scope and warranty under the Haven Standard. Chimney Repair in Des Moines includes tuckpointing, crown rebuilding, and structural assessment with photo documentation.
Fireplace Services in Des Moines
Factory-built fireplace units in Des Moines split-levels need annual inspection for rusted chase covers and deteriorated termination caps. We service gas and wood-burning systems, replace damaged components, and verify clearances to combustibles. Fireplace Services in Des Moines includes inspection, repair, and safety verification with written documentation.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterChimney Cap & Crown in Des Moines
Cap and crown work is our most frequent call in Des Moines, and for good reason: the salt air, constant humidity, and moss-friendly climate destroy these protective components faster than almost anywhere in south King County. The original concrete crowns on 1960s and 1970s ranch homes are typically cracked and porous by now, and standard galvanized caps rust through in a few seasons. We install caps and rebuild crowns with materials sourced through our Haven buying network - Famco, Copperfield, and DuraFlex products spec’d for marine environments. Chimney Cap & Crown details our full approach.
Cap Installation
Signs you need it
Water dripping down the flue, rust stains on the firebox walls, or birds nesting in an uncapped flue top.
What it costs in Des Moines
Single-flue cap installation runs $350-$650; wind-directional caps for bluff-exposed homes run $550-$850.
How we do it
We measure the flue tile or liner OD, select a stainless or copper cap with proper mesh screening, and secure it with masonry screws or a collar clamp depending on the flue type.
Crown Repair
Signs you need it
Cracks wider than 1/8 inch visible from the roof, pieces of concrete missing, or water pooling on the crown surface.
What it costs in Des Moines
Crown crack repair and resurfacing runs $450-$950; full crown teardown and rebuild runs $1,200-$1,800.
How we do it
We grind out cracks, apply a bonding agent, pour new high-strength concrete with a proper wash slope, and seal with a breathable masonry sealer rated for freeze-thaw cycles.
What Chimney Cap & Crown Costs in Des Moines
| Item | Typical range in Des Moines |
|---|---|
| Single-flue cap installation | $350 - $650 |
| Wind-directional cap installation | $550 - $850 |
| Crown crack repair / resurfacing | $450 - $950 |
| Full crown rebuild | $1,200 - $1,800 |
Can a cracked chimney crown be repaired, or does it need full replacement?
Cracks under 1/4 inch with no spalling can be routed, filled, and resurfaced; deeper cracking or concrete degradation requires teardown and rebuild. We show you the camera footage and give a written price for either option before work starts. Call (425) 642-3485 for a free estimate.
How long does a chimney cap last in Des Moines’s salt air?
Stainless steel and copper caps last 15-25 years; galvanized steel rusts through in 3-7 years in this environment. We stock marine-grade stainless and copper through our Famco and Copperfield supply chain. Call (425) 642-3485 for a free estimate.
Chimney Liner & Rebuild in Des Moines
Des Moines’s mid-century housing stock means we’re regularly pulling failed clay tile liners from 1960s chimneys that have absorbed decades of Puget Sound moisture. Cracked tiles, spalled flue surfaces, and leaking flue gases into wall cavities are the usual findings. When the liner is compromised or the structure itself has deteriorated, we install stainless or flexible liners and rebuild as needed. Chimney Liner & Rebuild covers our full process.
Stainless Steel Liner
Signs you need it
Cracked or missing clay tiles visible on camera scan, flue gas odor in the home, or a home inspector flagged the chimney for sale.
What it costs in Des Moines
Stainless steel liner installation runs $2,500-$4,500 for a typical single-flue system.
How we do it
We drop a rigid or segmented stainless liner down the flue, insulate with poured vermiculite or wrap insulation, and terminate with a properly sized cap.
Partial Rebuild
Signs you need it
Spalled brick above the roofline, leaning chimney stack, or mortar joints eroded to finger-width gaps.
What it costs in Des Moines
Partial rebuild of the upper chimney structure runs $3,500-$6,500 depending on height and access.
How we do it
We dismantle to sound masonry, rebuild with matching brick and Type S mortar, install a new crown with proper wash and drip edge, and document with before-and-after photos.
What Chimney Liner & Rebuild Costs in Des Moines
| Item | Typical range in Des Moines |
|---|---|
| Stainless steel liner installation | $2,500 - $4,500 |
| Flexible liner installation | $2,000 - $3,800 |
| Partial chimney rebuild | $3,500 - $6,500 |
| Full chimney rebuild | $8,000 - $15,000 |
Do I need a new liner, or can my clay tiles be repaired?
Individual cracked tiles can be replaced if the surrounding system is sound; widespread cracking, spalling, or shifting indicates a full liner replacement. We show you the camera footage and explain which condition applies. Call (425) 642-3485 for a free estimate.
How long does a stainless steel liner last?
Properly installed 316Ti stainless liners carry a lifetime warranty and typically last 20-30 years in residential use. We source DuraFlex and HeatShield products through our Haven buying network. Call (425) 642-3485 for a free estimate.
Brands We Service in Des Moines
We stock and install Famco caps, Copperfield flashing and sealants, DuraFlex liners, and HeatShield cerfractory resurfacing products through our Haven buying network. Most standard items are on our Seattle-area service vehicles, so Des Moines jobs rarely wait for parts.
Pricing for Chimney Cleaning in Des Moines, WA
| Service | Typical range in Des Moines |
|---|---|
| Chimney sweep & Level 2 inspection | $250 - $400 |
| Single-flue cap installation | $350 - $650 |
| Wind-directional cap installation | $550 - $850 |
| Crown crack repair / resurfacing | $450 - $950 |
| Full crown rebuild | $1,200 - $1,800 |
| Stainless steel liner installation | $2,500 - $4,500 |
| Flexible liner installation | $2,000 - $3,800 |
| Partial chimney rebuild | $3,500 - $6,500 |
| Full chimney rebuild | $8,000 - $15,000 |
Des Moines prices run slightly above inland south King County due to marine-environment material specs and access challenges on bluff properties. Every job gets a written price before work starts - Haven Standard Clause 1, no exceptions.
Neighborhoods We Serve in Des Moines
We work across Des Moines from the marina to the I-5 corridor, with scheduling coordinated from our Seattle office. Response time is typically 1-3 business days for non-urgent bookings.
- Waterfront / Marina District
- Des Moines Beach Park area
- Midway / Woodmont
- Redondo / North Hill
- Gregory Heights
Service Area - Cities Near Des Moines
Our crews serve south King County and the Eastside from our Seattle dispatch office. We regularly work in Kirkland, WA, Redmond, WA, Bellevue, WA, and Bothell, WA, plus Des Moines and surrounding communities.
Serving Des Moines, WA - Our Local Coverage Area
We’re based in the Des Moines area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Chimney Cleaning in Des Moines
Most chimney repairs and liner replacements require a King County permit; cap installations and standard sweeps typically do not. We handle permit applications as part of any job that requires them, and the cost is listed in your written estimate.
We typically book 1-3 business days out for routine sweeps and inspections in Des Moines. Emergency calls for suspected blockages or venting issues get same-day assessment when possible. Call (425) 642-3485 to check current availability.
Yes, we work with individual owners and HOA property managers throughout Des Moines. Multi-unit buildings often need coordinated roof access; we arrange this directly with your HOA or building manager and document everything under Haven Standard Clause 4.
What happens when you call
- 1A real person answersNo phone trees - talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Des Moines Customers Say
"Cap and crown replaced after water was getting in. Price was quoted in writing, and they showed me the mortar failure first."
- Neil O."Found a bird nest and a blocked flue we had no idea about. Photographed everything, cleared it, and explained what the smell had been."
- Curtis V."Clean, careful, put down sheeting, and the fireplace works properly for the first time since we moved in."
- Yvette S.